G. L. Grumpy
Joined: 01 Dec 2005 Posts: 261 Location: Huntington, IN 46750
|
Posted: Tue Jan 20, 2009 2:06 pm Post subject: Good parts Day! RTI clutch |
|
|
Been looking for used 10" RTI clutch. Not much luck. Today I went to Ft.Wayne clutch to see what they could do. Older fella there had the cast part of pressure plate I needed. Only $25 New for a listed $125 part. Can't buy used for that I bet. Mine was a Rockford clutch, he recognized right away. The disc is being recovered for $68 and will be good to go. Hurrah! Those guys are great with the old stuff.
Also found a bearing to fit the Kneadler type seats like I have on my BG. 1" OD with flange and 3/8" bolt hole/center. These are not sealed, but a small opening. A washer over them might work fine. Not sure if origs were sealed or not, mine were all pounded to death. Got these at Applied IND Technologies (Bearings Inc) and are Killian F-225 at $4.72 each. I got one to try/fit but don't see a problem yet. Will get the 8 or 10 needed later if they fit. _________________ G. L. Grumpy
Huntington, IN
RTI with Lull Loader
Power King
36 JT with RE engine
50 RTU
55 BG 1-row |
|